6 – 62 HEIDENHAIN Service Manual iTNC 530 HSCI
For detailed descriptions on how to interchange devices, please refer to the respective chapters of this
Service Manual or to the Service Manual for Inverter Systems and Motors.
Interchanging position encoders --> See ”Position encoders” on page 19 – 277.
Interchanging speed encoders --> See ”Speed encoders” on page 19 – 300.
Interchanging PWM interfaces --> See ”Error finding: Axes swapping” on page 21 – 341.
Interchanging motor outputs --> See ”Error finding: Axes swapping” on page 21 – 341.
Interchanging expansion boards --> See ”Error finding: Swapping the HEIDENHAIN expansion
boards for the SIMODRIVE 611 system” on page 21 – 347.
Interchanging inverters, motors --> See "Service Manual for Inverter Systems and Motors".
When troubleshooting do not connect obviously defective devices (e.g. position encoder with
short circuit caused by ingress of moisture) to other interfaces (e.g. X201 - X206) of the control.
To Next Page
Loading...
