HEIDENHAIN iTNC 530 HSCI - Page 619

31 – 620 HEIDENHAIN Service Manual iTNC 530 HSCI
MP7266.34 PLC value (P1)
MP7266.35 PLC value (P2)
MP7266.36 PLC value (P3)
MP7266.37 Additional kinematics description (KINEMATIC)
MP7266.38 Point angle for DRILL and CSINK (T-ANGLE)
MP7266.39 Thread pitch for TAP (PITCH)
MP7266.40 Control strategy name for AFC (Adaptive Feed Control)
MP7266.41 Tolerance value or tool radius R2 (R2TOL)
MP7266.42 Compensation value table for 3DToolComp (DR2TABLE)
MP7266.43 Time stamp during tool changing (LAST_USE)
MP7267 Elements of the pocket table
MP7267 can also be overwritten by the PLC and the LSV2 protocol.
Input: 0: No display
1 to 99: Position in the pocket table
CN123
MP7267.0 Tool number (T)
MP7267.1 Special tool (ST)
MP7267.2 Fixed pocket (F)
MP7267.3 Locked pocket (L)
MP7267.4 PLC status (PLC)
MP7267.5 Tool name (TNAME)
MP7267.6 Comment on the tool (DOC)
MP7267.7 Tool type for pocket table (PTYP)
MP7267.8 Value 1 (P1)
MP7267.9 Value 2 (P2)
MP7267.10 Value 3 (P3)
MP7267.11 Value 4 (P4)
MP7267.12 Value 5 (P5)
MP7267.13 Reserve pocket (RSV)
MP7267.14 Pocket above locked (LOCKED_ABOVE)
MP7267.15 Pocket below locked (LOCKED_BELOW)
MP7267.16 Pocket at left locked (LOCKED_LEFT)
MP7267.17 Pocket at right locked (LOCKED_RIGHT)
MP7267.18 S1 value (P6)
MP7267.19 S2 value (P7)
MP7270 Feed rate display in the operating modes MANUAL OPERATION and ELECTRONIC
HANDWHEEL
Input: 0: Display of axis feed rate through pressing an axis direction key
(axis-specific feed rate from MP1020)
1: Display of axis feed rate also before an axis direction key is pressed
(smallest value from MP1020 for all axes)
PLC
RUN
CN123
MP7280 Decimal character
Input: 0: Decimal comma
1: Decimal point
PLC
RUN
CN123
MP7281 Depiction of the NC program
Input: 0: All blocks completely
1: Current block completely, others line by line
2: All blocks line by line; complete block when editing
PLC
RUN
CN123
MP7285 Tool length offset in the tool-axis position display
Input: 0: Tool length is not offset
1: Tool length is offset
PLC
RUN
CN123
MP Function and input Software
version and
behavior