31 – 622 HEIDENHAIN Service Manual iTNC 530 HSCI
MP7310 Graphic display mode
Format: %xxxxxxxx
Input: Bit 0 – Projection in three planes:
0: German-preferred projection
1: US-preferred projection
Bit 1 – Rotating the coordinate system in the working plane by 90°:
0: No rotation
1: Rotation by +90°
Bit 2 – BLK form after datum shift:
0: Shifted
1: Not shifted
Bit 3 – Display of the cursor position:
0: Not displayed
1: Displayed
Bit 4 – Reserved
Bit 5 – 3-D graphics during program test
0: 2,5 D and 3 D (only with MC 420 or MC 422B and higher)
1: 2,5 D
Bit 6 – Stock removal with an inclined tool
0: Not active
1: Active
Bit 6 – Exact evaluation of the column LCUTS (cutting length) from the
TOOL.T table in order to display special tools (e.g. saw blade).
0: Free evaluation
1: Exact evaluation for special tools
PLC
RUN
CN123
MP7312 Limitation of the tool tooth length LCUTS if no value was given for the tooth length in the
tool table
Input: = 0: No limitation, infinitely long tooth length
> 0: Tooth length = 2 * tool radius * MP7312
PLC
RUN
MP7315 Tool radius for graphic simulation without TOOL CALL
Input: 0.0000 to 99 999.9999 [mm]
PLC
RUN
CN123
MP7316 Penetration depth of the tool
Input: 0.0000 to 99 999.9999 [mm]
PLC
RUN
CN123
MP7317 M function for graphic simulation PLC
RUN
CN123
MP7317.0 Beginning of graphic simulation
Input: 0 to 88
MP7317.1 Interruption of the graphic simulation
Input: 0 to 88
MP7330.0-15 Specification of user parameters 1 to 16
Input: 0 to 9999.00 (no. of the user parameter)
PLC
RUN
MP7340.0-15 Dialog messages for user parameters 1 to 16
Input: 0 to 4095 (line number of the PLC dialog message file)
PLC
RUN
MP Function and input Software
version and
behavior
To Next Page
Loading...
