31 – 634 HEIDENHAIN Service Manual iTNC 530 HSCI
MP7670 Subdivision factor for handwheel
Input: 0 to 10
PLC
RUN
MP7670.0 Subdivision factor for slow speed
MP7670.1 Subdivision factor for medium speed (only HR 410)
MP7670.2 Subdivision factor for fast speed (only HR 410)
MP7671 Handwheel feed rate in the Handwheel operating mode with HR 410
Input: 0 to 1000 [% of MP1020]
PLC
RUN
MP7671.0 Low speed
MP7671.1 Medium speed (only HR 410)
MP7671.2 Fast speed (only HR 410)
MP7672 HR 410, distance per handwheel step
Input: 0.0000 to 1.0000 [mm]
MP7672.0 Low speed
MP7672.1 Medium speed
MP7672.2 Fast speed
MP7674.x Handwheel, axis-specific subdivision factor
Input: 1 to 10
0: No limitation
PLC
RUN
MP7675.x Handwheel, axis-specific maximum path
Input: 0.0001 to 10.0000 [mm]
0: No limitation
PLC
RUN
MP7680 Machine parameter with multiple function
Format: %xxxxxxxxxxxxxxx
Input: Bit 0 – Memory function for axis-direction keys with M4562
0: Not saved
1: Saved if M4562 is set
Bit 1 – Returning to the contour
0: Not active
1: Active
Bit 2 – Block scan
0: Not active
1: Active
Bit 3 – Interruption of block scan for STOP or M06
0: Interruption
1: No interruption
Bit 4 – Inclusion of programmed dwell time during the block scan
0: Include the dwell time
1: Do not include the dwell time
Bit 5 – Start of calculation for block scan
0: Start from block with cursor
1: Start from beginning of program
Bit 6 – Tool length in blocks with normal vectors
0: Without R2 from tool table (south pole)
1: With R2 from tool table (center of sphere)
Bit 7 – Inserting a defined rounding arc or spline
0: Defined rounding arcs are always inserted
1: Defined rounding arcs are always inserted if the acceleration
from MP1060.x or MP1070 was exceeded
PLC
RUN
MP Function and input Software
version and
behavior
To Next Page
Loading...
