31 – 636 HEIDENHAIN Service Manual iTNC 530 HSCI
MP7682 Machine parameter with multiple function
Format: %xxxxxxxxxxxxxxx
Input: Bit 0 – Incremental block after TOOL CALL
0: With length compensation
1: Without length compensation
Bit 1 – Reference value for calculating the preset during datum setting
0: Actual value is calculated
1: Nominal value is calculated
Bit 2 – Traverse path of rotary axes with modulo display
0: Positioning without passing over zero
1: Positioning on the shortest path
Bit 3 – Reserved, enter 0
Bit 4 – Tolerance for compensating movements with tilting axes (M114)
0: Tolerance will be included
1: Tolerance will not be included
Bit 5 – Feed rate with M128 or TCPM
0: Feed rate refers to tool tip
1: Feed rate from interpolation of all axes involved
Bit 6 – Behavior with TOOL DEF strobe
0: Depending on the NC program, the TOOL DEF strobe must be
acknowledged by the PLC (TOOL DEF within a continuous contour)
1: TOOL DEF strobe must always be acknowledged by the PLC
Bit 7 – Block elements TOOL CALL and S in ISO blocks
0: Machine as programmed
1: Machine at beginning of block (block display does not change)
Bit 8 – Behavior of M8 at the end of Cycles 202 and 204
0: At the end of Cycles 202 and 204, the status of M8 is restored to that
before the cycle call (behavior until now).
1: At the end of Cycles 202 and 204, the status of M8 is not restored
automatically.
PLC
RUN
MP7682 Bit 9 – Loading of "Tilted working plane" status
0: The "tilted working plane" status is not applied to the Manual
Operation mode after a program interruption (behavior until now).
1: The "Tilted working plane" status is loaded into the Manual Operation
mode after a program interruption
Bit 10 – Peripheral milling active/inactive
0: Peripheral milling allowed
1: Peripheral milling inactive
Bit 11 – Reserved
Bit 12 – Error message "Tool radius too large" is suppressed if R2 > R
0: Error message is displayed
1: Error message is suppressed
Bit 13 – No program interruption upon invalid TOOL DEF
0: Error message and NC stop upon invalid TOOL DEF
1: Only warning upon invalid TOOL DEF
Bit 14 – No insertion of the tool if TIME2 has expired
0: Tool is inserted even if TIME2 has expired
1: TOOL CALL for a tool where TIME2 has expired leads to an error
message and NC stop
MP Function and input Software
version and
behavior
To Next Page
Loading...
