HEIDENHAIN iTNC 530 HSCI - Page 637

31 – 638 HEIDENHAIN Service Manual iTNC 530 HSCI
MP7684 Nominal position value filter (bit 0 to bit 4) and path control with M128 or TCPM (bit 5 to
bit 7)
Format: %xxxxxxxx
Input: Bit 0 – Nominal position value filter
0: Include acceleration
1: Do not include the acceleration
Bit 1 – Nominal position value filter
0: Include the jerk
1: Do not include the jerk
Bit 2 – Nominal position value filter
0: Include the tolerance
1: Do not include the tolerance
Bit 3 – Nominal position value filter
0: Include the radial acceleration
1: Do not include the radial acceleration
Bit 4 – Nominal position value filter
0: Include jerk and tolerance limit at changes in the curvature
1: Do not include jerk and tolerance limit at changes in the curvature
Bit 5 – Reserved
Bit 6 – Reserved
Bit 7 – Reserved
Bit 8 – Reserved
Bit 9 – Accelerated 5-axis machining with M128 with many rotary axis motions that are
less than 2° per positioning block (not with handwheel superimpositioning with M118)
0: Inactive
1: Active
Bit 10 - Modification of the calculation of the contouring feed rate at the beginning of a
contour element
0: Active
1: Inactive
PLC
RUN
MP7690 Evaluation of the electronic ID labels
Input: %xxx
Bit 0 – HEIDENHAIN power modules
0: Active
1: Inactive
Bit 1 – HEIDENHAIN synchronous motors
0: Active
1: Inactive
Bit 2 – HEIDENHAIN power supply units
0: Active
1: Inactive
MP Function and input Software
version and
behavior