HEIDENHAIN iTNC 530 HSCI - Page 87

8 – 88 HEIDENHAIN Service Manual iTNC 530 HSCI
Entry of
NC programs
Not every single block of an NC program is recorded in the log (as the size of the log file has not been
designed for this purpose). Information is recorded at the start and at the end of an NC program.
Figure: Example for information at end of program
Here, an NC program was finished properly:
 STIB: OFF
The machine does not operate any more; the "*" in the display goes out.
 INFO: MAIN PGMEND
The code 00 06 in the second line means END PGM, M02.
(See ”Overview of log entries” on page 8 – 83.)
 INFO: MAIN PGMEND
Information about the end of program in plain language.