February 2012 10 – 99
a actual Actual value of the acceleration; calculated from position encoder [m/s
2
] or [°/s
2
]
r actual Actual value of the jerk; calculated from position encoder [m/s
3
] or [°/s
3
]
I2-t (mot.) Current value of the I
2
-t monitoring of the motor [%]
I2-t (p.m.) Current value of the I
2
t monitoring of the power module [%]
Utilization Current utilization of the drive [%]
Block number Block numbers of the NC program -
Gantry Diff Difference between synchronized axes [mm]
U nominal Nominal voltage [V]
P mech. Mechanical power [kW]
P elec. Electrical power [kW]
M actual Actual value of the torque [Nm]
s noml (f.) Nominal position as per nominal position value filter [mm]
DSP debug Diagnosis function for internal purposes -
Contour
deviat.
Circular interpolation test, contour deviation [mm] [mm]
F TCPM Feed rate at the tool tip with TCPM [mm/min]
Int. diagn. Reserved for internal purposes -
DC-link P DC-link power (if MP2198.x and MP2199.x are configured) [kW]
Amplitude Amplitude of the position encoder [mV]
Motor: A Signal A of the speed encoder [mV]
Motor: B Signal B of the speed encoder [mV]
CC DIAG Axis-specific signal with additional input box.
Consult your machine manufacturer or a HEIDENHAIN service agency.
-
SPLC Reserved -
SPLC-CC Reserved -
Compensat. Position compensation value (composed of temperature compensation, axis-error
compensation, backlash compensation, etc.)
[mm] or [°]
I actual Actual value of current [A]
Actl. Id Actual value of magnetizing current [A]
Max. Iq Maximum torque current [A]
Signal Meaning Unit
For the CC 610x and the UEC 1xx controller units, the current signals are displayed as effective
values in the integrated oscilloscope.
The oscillogram remains stored until you start a new recording.
To Next Page
Loading...
