12 Tables, Overviews and Dialogs
L
12.1 General User Parameters
TNC &plays, TNC &tw
Configuration of tool pocket table; column number in the tool table for (do not execute: 0)
. .
L
L
MP7267.0 Tool number -T: 0 to 5
MP7267.1 Special tool - ST: 0 to 5
MP7267.2 Fixed pocket - F: 0 to 5
MP7267.3 Pocket locked - L: 0 to 5
MP7267.4 PLC status - PLC: 0 to 5
Settings for MANUAL OPERATION mode
MP7270 Do not display feed rate: +O
Display feed rate: +I
Spindle speed S and M functions still active after STOP: +O
Spindle speed S and M functions no longer active after STOP: +2
Decimal character
MP7260 Decimal comma: 0
Decimal point: 1
Display step for coordinate axes
MP7260 0.001 mm: 0
0.005 mm: 1
Reset status display, 0 parameters and tool data
MP7300 Do not reset Q parameters and status display: +O
Reset Q parameters and status display with M02, M30 and END PGM: +I
Do not activate last programmed tool data after power interruption: +O
Activate last programmed tool data after power interruption: +4
Graphics display
MP7370 Projection in 3 planes according to IS0 6433, projection method 1: +O
Projection in 3 planes according to IS0 6433, projection method 2: +7
Do not rotate coordinate system for graphics display: +O
Rotate coordinate system for graphics display by 90”: +2
L
TNC 370
12-7
To Next Page
Loading...
