12 Tables, Overviews and Dialoas
12.1 General User Parameters
Programming station
MP7210 TNC with machine: 0
TNC as programming station with active PLC: 7
TNC as programming station with inactive PLC: 2
Block number increment with IS0 programming
MP7220 0 to 750
Dialog language
MP7230 German: 0
English: 1
Configuration of tool tables
MP7260
Not active: 0
Number of tools per tool table: 7 to 99
Configuration of tool pocket tables
MP7261 Not active: 0
Number of pockets per pocket table: 1 to 99
Number of reserved pockets next to special tools in pocket tables
MP7264 0 to 3
Configuration of tool tables; column number in the tool table for (do not execute: 0)
MP7266.0
MP7266.1
MP7266.2
MP7266.3
MP7266.4
MP7266.5
MP7266.6
MP7266.7
MP7266.8
MP7266.9
MP7266.10
MP7266.11
MP7266.12
MP7266.13
MP7266.14
MP7255.15
MP7266.16
MP7266.17
MP7266.18
MP7266.19
MP7266.20
MP7266.2 1
Tool name - NAME: 0 to 22
Tool length - L: 0 to 22
Tool radius - R: 0 to 22
not used
Tool length oversize - DL: 0 to 22
Tool radius oversize - DR: 0 to 22
not used
Tool locked - TL: 0 to 22
Replacement tool - RT: 0 to 22
Maximum tool life - TIME1 : 0 to 22
Maximum tool life for TOOL CALL - TIME2: 0 to 22
Current tool age - CUR. TIME: 0 to 22
Tool description - DOC: 0 to 22
Number of teeth - CUT.: 0 to 22
Wear tolerance for tool length - LTOL: 0 to 22
Wear tolerance for tool radius - RTOL: 0 to 22
Cutting direction - DIRECT.: 0 to 22
PLC status - PLC: 0 to 22
Tool end offset in addition to MP6530 from top of stylus - lT:L-OFFS.: 0 to 22
Tool offset between stylus center and tool center - lT:R-OFFS.: 0 to 22
Breakage tolerance for tool length - LBREAK: 0 to 22
Breakage tolerance for tool radius - RBREAK: 0 to 22
-4
4
-I
-
12-6 TNC 370
To Next Page
Loading...
