12 Tables, Overviews and Dialogs
L
12.5 TNC Error Messages
l
Enter the feed rate for the positioning block
l
Enter FMAX in each block.
L
L
GROSS PQSITIQNING ERROR
The TNC monitors positions and movements. If the actual position
deviates to greatly from the nominal position, this blinking error message
is displayed. Press the END key for a few seconds to acknowledge the
error message (warm start).
KEY NUN-rnNCTIQNAI,
This message always appears when you press a key that is not needed
for the current dialog.
You can only call labels numbers that have been assigned.
Do not cancel tool radius compensation in a block with a circular
path.
l
Use the same radius compensation before and after a RND and CHF
block.
l
Do not begin tool radius compensation in a block with a circular path.
L
l
Enter a smaller tool radius.
l
Movements in a rotary axis cannot be graphically simulated.
l
Enter a tool axis for simulation that is the same as the axis in the BLK
FORM.
PLANE WRfXWLY DEFINRD
,N.,
3
l
Do not change the tool axis while a basic rotation is active.
l
Define the main axes for circular arcs correctly.
l
Define both main axes for CC.
PROBE SYSTEM NOT READY
1
l
Orient transmitting/receiving window of TS 630 to face receiving unit.
l
Check whether the touch probe is ready for operation.
l
Begin the program only with a TOOL DEF block.
l
Do not resume an interrupted program at a block with a tangential arc
or pole transfer.
L
TNC 370
12-1s
To Next Page
Loading...
