12 Tables, Overviews and Dialoas
12.5 TNC Error Messages
Enter radius compensation in the first subprogram to Cycle 14:
CONTOUR GEOM.
ROUNDING-OFIF x7llmrnND
Enter tangentially connecting arcs and rounding arcs correctly.
1
ROUNDING RADMS TOU LARGE
Rounding arcs must fit between contour elements.
Before a test run or program run you must go to the beginning of the
program by entering GOT0 0.
ALREAnY @I CONTACT
Before probing, pre-position the stylus so that it is not touching the
workpiece surface.
Enter a tool radius that
l
lies within the given limits, and
l
permits the contour elements to be calculated and machined.
TOUCH POINT INACCESSTHLE
Pre-position the 3D touch probe to a point nearer the surface.
l
Do not attempt to program locked axes.
l
Program a rectangular pocket or slot in the working plane
l
Do not mirror rotary axes,
l
Chamfer length must be positive.
WRONG RPM
Program a spindle speed within the permissible range.
WRUNG SIGN PROG-
Enter the correct sign for the cycle parameter.
4
4
J
d
-
12-20
TNC 370
To Next Page
Loading...
