12 Tables, Overviews and Dialogs
L
12.5 TNC Error Messages
TNC error messages during digitizing
Program two different axes for the coordinates of the starting point
(CONTOUR LINES cycle).
L
L
DA’IWlM SIIiFl’ NUT PERMITTED
Reset all coordinate transformations before digitizing.
EXCHANGE TOWI% PROBE BATTERY
Exchange the battery in the touch probe head. This message is dis-
played when the probe reaches the end of a line.
FAULT-57 RANGE DATA
1
l
Enter MIN coordinates that are smaller than their MAX coordinates.
l
Define the RANGE within the limits set by software limit switches.
l
Define the RANGE for the MEANDER and CONTOUR LINES cycles.
MIRRWING NO’S H%tMITTED
Reset all coordinate transformations before digitizing.
I’LANE WRONGLY DEJJKNED
Define the starting position coordinates (CONTOUR LINES cycle) in
axes different from the stylus axis.
I
l
Orient transmitting/receiving window of TS 630 to face receiving unit.
l
Check that the touch probe is ready for operation.
l
The touch probe cannot be retracted (collision with workpiece).
RANGE EXCEEDED
Enter a RANGE that includes the entire 3D surface to be scanned.
I
ROTATION NOT PERMITTED
Reset all coordinate transformations before digitizing.
SCALING FACTOR NOT PERMITTED
Reset all coordinate transformations before drgitizing.
START PClSITKhN INCORRECT
Program the starting point coordinates for the CONTOUR LINES cycle
so that they lie within the RANGE.
L
TNC 370 12-21
To Next Page
Loading...
