1
Introduction
L.
1.4 Graphics and Status Display
Coordinate transformations
KTL. x
-4,985 T 12 2
I
+39,175 0
Iam
+138>066
H5/9
C +180,088
Results of automatic tool measurement
‘ROGRRM RUN, FULL SEQUENCE
3
ICTL. x
-25,566 T
I
+21,325
q
+150.000
C +9a.aaa
Active program / Current block number
Active rotation angle defined in Cycle IO
Mirrored axis defined in Cycle 8
Active datum shift defined in Cycle 7
Active scaling factor defined in Cycle 11
Number of the tool measured
Measured MIN and MAX values of the
single cutting edges and the result of
measuring the rotating tool
Cutting edge number with the correspond-
ing measured value. If the measured value
is followed by an asterisk (*), the allow-
able wear tolerance defined in the tool
table was exceeded. If the measured
value is followed by the letter B, the
allowable break tolerance defined in the
tool table was exceeded.
TNC 370
1-33
To Next Page
Loading...
