Private Port: Default value is 6000, according to the actual needs of
users to set the port.
Network Rate: Displays the network transmission rate.
Internal Net Card IP: Set the intranet IP address for connecting the POE
device of the device.
Refresh: Click to refresh the interface.
NOTE
The IP address and the default gateway must be in the same network
segment.
If NVR enabled DHCP is in effect and you turn off DHCP, you cannot
display the original IP information. You need to reset the IP address and
other parameters.
Only PoE-capable devices have an internal network card function.
Please refer to the actual product.
The internal network adapter IP and NVR IP address cannot be on the
same network segment.
After the DDNS (Dynamic Domain Name Server) parameter is set, when the
IP address of the NVR device changes frequently, the system can dynamically
update the relationship between the domain name and the IP address on the
DNS server. You can use the domain name to access the NVR directly without
recording the constantly changing IP address.
Prerequisites
Before configuring DDNS, make sure that the device supports the type of
domain name resolution server, and log in to the DDNS service provider's
website to register user name, password, domain name, and other
information on the WAN PC.
The specific operation steps are as follows:
Step 1: On the menu page, select " →TCP/IP →DDNS" to enter the
DDNS interface, as shown in Figure 5-44.
To Next Page
Loading...