filtering time is set. During this time period, the camera is not
disturbed by ambient light.
Light brightness: It is used to adjust the brightness of fill light, and
the adjustable range is 0-100.
Exposure setting: The default is Auto, which switches the Manual mode
according to actual needs. When "Manual" is selected, the exposure
time and gain control are activated.
Backlight: It is used to set backlight compensation and strong light
suppression. The default is off, it can be turned on manually, and the
backlight can be set.
White balance: The default is auto and can be switched to "Manual".
Manual white balance: Support R, G, B gain adjustable, adjustment
range is (0-255), please click "Save" after setting.
Video adjustment: Here you can turn on and set 2D or 3D digital noise
reduction.
Image enhancement: Here you can select the flicker control mode, turn
on and set the wide dynamic intensity.
Flicker control : The flicker control mode is selected according to
the IPC installation environment and the flicker standard. The PAL
standard is 50HZ and the NTSC standard is 60HZ. When the device
is installed outdoors, it can be selected outdoor. The default setting
is PAL.
Sensor linear WDR: The default is "Shutdown", you can switch the
wide dynamic strength (Automatic, Weak, Moderate, Strong, Super)
in the drop-down menu.
Defog mode: Used to set the defogging mode and strength.
Defog mode: The default is off, and you can select On or Auto from
the drop-down menu.
Defog strength: The default is 0. When the defogging mode is on,
the defogging intensity can be set. The range of values can be set
from 0-255.
NOTE
The camera image interface only displays the device support functions.
The specific interface is subject to the actual product.
4.5.3 Fisheye Unfold
To Next Page
Loading...