change according to the scene.
Constant bit rate: The bit rate
should be encoded according to
the upper limit of the bit rate, and
the video quality cannot be
adjusted.
Video frame rate refers to the
number of video frames per second
Set the code stream value to
change the quality of the image
quality, the larger the code stream,
the better the image quality.
Modify it directly in the
input box.
Select through the
drop-down box.
NOTE:
The encoding type is
related to the IP device.
Table 5-5
Steps 3: Click "Apply" to save the setting.
5.3.6 Storage
Storage is composed of Record, Storage Device, Storage Mode, Auto Backup
and Advanced.
5.3.6.1 Record
NVR supports two recording plan, drawing method and editing method.
Set the recording plan by drawing method
The specific operation steps are as follows:
Step 1: In the main menu, click " →Record" to enter Record Setup
interface, as shown in Figure 5-39
○
1
below.
To Next Page
Loading...