Click to delete all recording settings.
Click to set all channels to normal video and motion
detection recording from Monday to Sunday.
Copy to. After setting the video for a certain day, click
" " to apply the settings of that day to other times.
Click one of the set recording time periods, pop up the time
period setting, select the recording type, set the time
period, and click "Save" to complete the setting. When you
click "Del", the selected time period is deleted.
Click to enter the pre-record time setting interface, set the
prerecord action status 0 seconds to 30 seconds before the
recording, click "OK".
Table 6-1
Steps 3: Click "Save" to complete configuration.
In the main interface, click "Configuration →Record →Encode" to enter the
encoding setting interface, as shown in Figure 6-14 below. Here you can view
and set the encoding parameter values for accessing the IPC. The relevant
parameters and NVR-side settings consistent.
To Next Page
Loading...