Figure 6-26
In the main interface, click "Configuration →System →Network →Address
Filter" to enter the Address Filter setting interface, as shown in Figure 6-27
below. Here you can enable and set the Address Filter function of the NVR,
the specific Address Filter settings are consistent with the NVR's local
settings.
Figure 6-27
6.5.4.3 User
In the main interface, click "Configuration →System →User" to enter the
User management interface, as shown in Figure 6-28 below.Here you can
add, delete, edit users, user settings are consistent with the local settings of
NVR.
To Next Page
Loading...