The enclosure operates visual indicators. These indicators can be set or cleared via host request, or
autonomously by the enclosure if it detects fault conditions. The enclosure provides non-volatile memory that
records enclosure serialization and branding information. The SEP records event log entries to non-volatile
memory. The SEP implements T10 defined SMP controlled “zoning on the fly”, and has the capability to save
the host defined zoning parameters in non-volatile memory. The SEP also implements several predefined
zoning configurations. These predefined configurations are selectable via SES control operations.
2.2 OOBM Management Overview
The Ultrastar Data60 uses an implementation of DMTF Redfish for out-of-band system management. All the
SES enclosure information can be obtained through the out-of-band management port using RESTful API
calls to the management port over HTTPS.
2.3 SCSI Enclosure Services Page 02
The SCSI Send Diagnostic and Receive Diagnostic Results commands can be addressed to a
specific SES element in the enclosure. There are many different element codes, such as Page 02, defined
to cover a wide range of devices. Page 02 refers to the control and status of the enclosures PSUs, HDDs,
ESMs, and sensors.
Note: Refer to the SES Firmware Management Interface Specification for more information on SES
Page 02.
33
2 System Management Overview
User Guide 2.2 OOBM Management Overview
To Next Page
Loading...
Need help?
General
