4. Push the enclosure back into the rack to ensure proper cooling.
4.6 Drive Assembly Replacement
Table 39: Replacement Procedure Info
Replacement WindowTime Required# of People RequiredRequired Tools
5 Minutes60s1None
1. Grasp both handles at the front of the enclosure and pull with even pressure to extend the chassis out of
the rack until it is stopped by the safety latches. The safety latches will prevent the enclosure from coming
out of the rack completely and the cover will remain in the rack attached to the rear alignment brackets.
Figure 55: Chassis Handle Operation
Only extend the enclosure out of the rack as far as is needed to reach the drive being replaced.
2. Locate the faulty Drive Assembly by finding the illuminated amber LED or by activating the identification
LED for the drive to be replaced.
Figure 56: HDD Assembly LED
3. Follow these steps to remove a Drive Assembly.
a) Find the latch release mechanism on the Drive Assembly being removed.
68
4 Part Replacement
User Guide 4.6 Drive Assembly Replacement
To Next Page
Loading...
Need help?
General
