Revision History
CommentRevisionDate
Initial ReleaseRevision 1.0November 2017
Revision 1.1November 2017 • The crossbar on the CMA was changed. See CMA
Description on page 47.
• Removed Lowline power specs from Detailed Power
Specifications.
• Changed required rack depth, see Required Rack Depth.
• Changed typical power consumption, see Typical Power
Consumption.
• Updated LED Flash Patterns, see LEDs on page 16.
Revision 1.2December 2017 • Added active cable support
• Added firmware upgrade section. See Firmware Upgrade
on page 146.
• Added a note regarding single IOMs in SATA TLAs. See
the list of features.
• Updated the Non-Op altitude specification. See
Non-Operational Altitude.
Updated the product nameRevision 1.21January 2018
Revision 1.3January 2018 • Updated information on the 2.5" drive carrier option. See
2.5" Drive Carrier Description on page 53.
• Added torque requirements for all screws used in the
enclosure.
• Updated the IOM replacement section to account for the
possibility of a firmware mismatch. See IOM Replacement
on page 57.
• Updated the drive assembly installation instructions to clarify
the orientation of the drive assemblies. Drive Assembly
Replacement on page 68.
Revision 1.4April 2018 • Updated Compatible Drives List. See List of Compatible
Drives on page 23.
• Updated the Rack Requirements. See Ultrastar Data60
Rack Requirements on page 214.
• Updated the Firmware Upgrades. See: Firmware Upgrade
on page 146
Added the Part Replacement Service Window. See: Part
Replacement Service Window on page 57
Revision 1.5May 2018
Revision 1.6June 2018 • Updated Compatible Drives List. See List of Compatible
Drives on page 23
• Updated the Firmware Upgrade section. See Firmware
Upgrade on page 146
• Updated the Firmware Download section. See
Downloading Firmware from the Support Portal on page
146
7
Revision History
User Guide
To Next Page
Loading...
Need help?
General
