HIKVISION DS-K1T341A Series

Face An-Spoong
If you check this funcon, then the device can detect whether the face to be collected is an
authenc one.
6. Collect face.
1) Face to the camera of the selected access control device and make sure your face is in the
middle of the collecng window.
2)
Click
to capture a photo.
3) Click OK to save the captured photo.
7. Conrm to add the person.
-
Click Add t
o add the person and close the Add Person window.
-
Click Add and New to add the person and connue to add other persons .
9.4.7 Collect Fingerprint via Client
Collecng
ngerprints locally means you can collect the ngerprint via the ngerprint recorder
connected directly to the PC running the client. The ngerprints recorded can be used as
credenals of the persons to access the authorized doors.
Before You Start
Connect the ngerprint recorder to the PC running the client.
St
eps
1. Enter Person module.
2. Select an organizaon in the organizaon list to add the person and click Add.
Note
Enter the person's basic informaon rst. For details about conguring person's basic
informaon, refer to Congure Basic Informaon .
3. In the Credenal → Fingerprint panel, click +.
4. In the pop-up window, select the collecon mode as Local.
5. Select the model of the connected ngerprint recorder.
Note
If the
ngerprint recorder is DS-K1F800-F, you can click Sengs to select the COM the
ngerprint recorder connects to.
6. Collect the ngerprint.
1) Click St
art.
2) Place and li your ngerprint on the ngerprint recorder to collect the ngerprint.
3) Click Add t
o save the recorded ngerprint.
7. Conrm to add the person.
-
Click Add to add the person and close the Add Person window.
-
Click Add and New to add the person and connue to add other persons.
DS-K1T341A Series Face
Recognion Terminal User Manual
105