HIKVISION DS-K1T341A Series

Note
If you select Access Con
troller: If connect the device to a terminal via the RS-485 interface, set
the RS-485 address as 2. If you connect the device to a controller, set the RS-485 address
according to the door No.
4. T
ap the back icon at the upper le corner and you should reboot the device if you change the
parameters.
7.2.3 Set Wiegand Parameters
You can set the Wiegand transmission direcon.
Steps
1. Tap Comm. (Communicaon Sengs) on the Home page to enter the Communicaon Sengs
page.
2. On the Communicaon Sengs page, tap Wiegand to enter the Wiegand tab.
DS-K1T341A Series Face Recognion Terminal User Manual
31