HIKVISION DS-K1T341A Series User Manual

Figure 7-10 Access Control Parameters
The available parameters descripons are as follows:
Table 7-2 Access Control Parameters Descripons
Parameter Descripon
Terminal Auth. Mode (Terminal
Authencaon Mode)
Select the face recognion terminal's authencaon mode. You
can also customize the authencaon mode.
Note
• Only the device with the ngerprint module supports the
ngerprint related funcon.
• Biometric recognion products are not 100% applicable to
an-spoong environments. If you require a higher security
le
vel, use mulple
authencaon modes.
• If you adopt mulple authencaon modes, you should
authencate other methods before authencang face.
Reader Auth. Mode (Card
Reader Authencaon Mode)
Select the card reader's authencaon mode.
Enable NFC Card Enable the funcon and you can present the NFC card to
authencate.
Door Contact You can select "Open (Remain Open)" or "Close (Remian
Closed)" according to your actual needs. By default, it is Close
(Remian Closed).
DS-K1T341A Series Face Recognion Terminal User Manual
46

HIKVISION DS-K1T341A Series Specifications

General

Brand	HIKVISION
Model	DS-K1T341A Series
Category	Touch terminals
Language	English