Chapter 2 Installation Preparations
Introduction
This chapter introduces the preparations before installing the SG-6000 A-Seriesnew series NIPS
device, including the installation site environment requirements, cabinet and rack requirements,
and unpacking. This chapter includes the following sections:
l Installation site environment requirements
l Cabinet requirements
l Rack requirements
l Verifying the parts received
l Unpacking
Installation Site Environment Requirements
The SG-6000XAnew NIPS-Series device is designed for indoor use. To ensure the normal oper-
ation and to prolong the service lifetime, the installation site must meet the requirements below.
Temperature/Humidity Requirements
The ambient temperature and relative humidity in the installation site should be maintained at
acceptable levels. The requirements are shown as below:
Item Requirements
Ambient Tem-
perature
When the device is working, the requirement is
between 0℃ and 40℃;
When the device is being stored, the requirement is
between -20℃ and 70℃.
Relative Humidity 10%-95%, non-condensing
Chapter 2 Installation Preparations 60
To Next Page
Loading...
Need help?
General