Hioki 3532-50 - Setting and Activating the Scaling; Control Screen Sequence

97
_____________________________________________________________________________________________
4.16 Setting and Activating the Scaling
______________________________________________________________________________________________
4.16.1 Control Screen Sequence
Scaling screen
Scaling screen
Initial screen
Menu screen
Application menu screen
Input compensation coefficient a or b
Compensation coefficient
setting screen
Compensation coefficient
setting screen
4.16 Setting and Activating the Scaling
Scaling applies a correction function to the measurement value. This
function can be used to provide compatibility among measurement devices.
Set the compensation coefficient a and b for the measurement values of the
first and third parameters to compensate by the following expression.
Y=ax X+b
X: the first or third parameter measurement value
Y: the last measurement value
a: integration value of the measured value X
b: the value added to measured value X
Here, when the parameter corresponding to X is either D or Q, the scaling is
applied to θ as follows:
θ '=ax θ +b
This gives a new value θ ', from which D or Q is obtained.
After powering off on the Scaling screen, the same screen is displayed when
the power is turned on again.
Press the key.
Press the key.
Press the key.
Activate the scaling function.
To change the compensation coefficient,
press the key.
Choose the compensation coefficient (a or b).
Input the compensation coefficients.
When the input is complete, press the key to
return to the Decision conditions setting screen.
When the setting has been established as above,
press the key to return to the Scaling screen.