Hioki 3532-50 - The EXT I;O Connector; Pinouts for the EXT I;O Connector

132
_____________________________________________________________________________________________
5.5 The EXT I/O Connector
______________________________________________________________________________________________
EXT I/O Connector Pin Numbering
(seen from 3532-50)
5.5.1 Pinouts for the EXT I/O Connector
Pin
number
Signal line name Input/output
1 INT.DCV Output
2 EXT.DCV Input
3 EXT.DCV Input
4 TRIG
__________
Input
5 LOCK
__________
Input
6 LD1
______
Input
7 LD2
______
Input
8 LD3
_______
Input
9 LD4
_______
Input
10 LD5
_______
Input
11 Unused
______
12 Unused
______
Pin
number
Signal line name Input/output
13 INT.GND Output
14 EXT.COM Input
15 EXT.COM Input
16 M-HI
________
Output
17 M-IN
________
Output
18 M-LO
________
Output
19 S-HI
________
Output
20 S-IN
_______
Output
21 S-LO
_______
Output
22 AND
_______
Output
23 INDEX
__________
Output
24 EOM
_______
Output
5.5 The EXT I/O Connector
This is a connector for output of comparator result signals, of a measurement
finished signal (EOM), and of an analog measurement finished signal
(INDEX), and for input of an external trigger signal, and a signal for
performing selection of the number of the panel to be loaded.
Connector used Hirose type RC10(F)-24R-LW 24-pin receptacle
Compatible connector Hirose type RC30-24P 24-pin receptacle
All input and output terminals excluding the power supply are all negative
logic.