Hioki 3532-50 - Panel Save Function

102
_____________________________________________________________________________________________
4.17 Panel Save Function
______________________________________________________________________________________________
4.17.1 Control Screen Sequence
Initial screen
Panel number
selection screen
Initial screen
Menu screen
Application menu screen
Saving name setting menu
4.17 Panel Save Function
All of the test conditions can be saved as a "panel", up to a maximum of 30
such stored panels (i.e., sets of stored test conditions).
The test conditions which are saved are:
Display parameters
Test range
Set value for averaging
Test frequency
Open and short circuit compensation values
Set value for test speed
Test signal level
Setting for trigger value
Beep sound setting
Voltage and current limit values
Set value for trigger delay
Comparator setting
Scaling setting
Display digits setting
Cable length setting
Display setting
Press the key.
Press the key.
Press the key.
Select the panel number under which settings will
be saved.
Set the saving name.
When the saving has been completed, the system
returns automatically to the Initial screen.
The saving has been performed.