108
_____________________________________________________________________________________________
4.18 Panel Load Function
______________________________________________________________________________________________
Saving name
Test conditions
to be loaded
NOTE
Stored using the comparator mod
6. A message requesting confirmation will be displayed. To continue, press the
key. The test conditions saved under the panel number which was
selected will be loaded in place of the present test conditions.
To change the panel number for the load, press the key, and the
previous screen will be displayed again.
When the new test conditions have been loaded, the display automatically
reverts to the Initial screen, on which the panel number from which the
newly loaded test conditions just came is displayed.
For test conditions saved with the comparator mode, the following mark is
displayed:
Under normal conditions of use, the average life of the backup battery is
about 10 years.
If the internal battery becomes exhausted, it is no longer possible to save the
test conditions. You should have the battery changed by an approved HIOKI
service facility (which is chargeable).
To Next Page
Loading...
