Hioki 3532-50 - External Interference

115
_____________________________________________________________________________________________
4.21 System Reset
______________________________________________________________________________________________
The settings established at the factory are as follows:
Test parameters
|Z|, θ
Test frequency
1kHz
Test signal level
Open circuit voltage (V) setting
Open circuit voltage (V) set value
1.000 V
Constant voltage (CV) set value
1.000 V
Constant current (CC) set value
10.00 mA
Limit function
OFF
Voltage limit set value
5.000 V
Current limit set value
50.00 mA
Test range
AUTO range
Open circuit compensation
OFF
Short circuit compensation
OFF
Trigger setting
Internal trigger
Trigger delay setting
0s
Averaging
OFF
Test speed setting
NORMAL
Cable length setting
0m
Beep sound setting
ON for key input, OFF for comparator
Panel save, panel load
All contents clear
Comparator
Comparator setting
Both first and third parameters set to
absolute value.
Absolute value set values
Upper and lower limit values for the first
and third parameters both OFF
Percent set values
First parameter reference value: 1000
Upper and lower limit values for first
parameter both OFF
Third parameter reference value: 10
Upper and lower limit values for third
parameter both OFF
Scaling setting value
Compensation coefficient a for the first
and third parameters: 1.0000
Compensation coefficient b for the first
and third parameters: 0
Display digits setting
All five digits for first to 4th parameters
Display setting
LCD display: ON
Voltage and Current monitor: ON