145
_____________________________________________________________________________________________
5.9 9442 Printer (option)
______________________________________________________________________________________________
Switch No. Function ON (ON LINE) OFF (FEED)
1 Input method Parallel Serial
2 Printing speed High Low
3 Auto loading Enable Off
4 CR function
Carriage return
and line feed
Carriage return
5
DIP SW setting
command
Enable Disable
6
Printing density
(set to 100%)
OFF
7 ON
8 ON
Switch No. Function ON (ON LINE) OFF (FEED)
1 Print mode
Normal printing
(40 columns)
Condensed printing
(80 columns)
2
User-defined
characters back-up
Enable Disable
3 Character type
Ordinary
characters
Special
characters
4 Zero font 0
5
International
character set
ON
6 ON
7 ON
8 ON
Switch No. Function ON OFF
1 Data bit length Eight bits Seven bits
2 Parity permission Without With
3 Parity condition Odd Even
4 Flow control H/W BUSY XON/XOFF
5
Baud rate
(19200bps)
OFF
6 ON
7 ON
8 OFF
4. "Dip SW-1" is printed to make a settings for switch number 1 to 8 of DIP
SW 1. Refer to the next table.
Software DIP SW1
Use these settings
for the 3532-50
To set to ON, press the ON LINE button once and to set to OFF, press the
FEED button once.
The setting is printed out after the ON LINE or FEED button is pressed to
allow to confirm the new setting. To change the settings, repeat from step 1.
When the setting for switch number 8 is made, the printer once again
prompts with "Continue? :Push 'On-line SW'", "Write?:Push 'Paper feed
SW'".
5. Set the switch number 1 to 8 of DIP SW 2 and 3 in the same way from step
3 referring to the following tables.
Software DIP SW2
Software DIP SW3
To Next Page
Loading...
