Hioki 3532-50 - Page 31

17
_____________________________________________________________________________________________
3.3 Basic Measurement
______________________________________________________________________________________________
Initial Screen
Parameter Setting Screen
NOTE
Initial Screen
3. In order to change the third parameter displayed
on the Initial screen, press the third parameter
key.
4. The Parameter setting screen is displayed.
Press on this screen, and the display will
automatically return to displaying the Initial
screen, with the loss coefficient D being
displayed as the third parameter.
If you press the key, instead of pressing a
soft key corresponding to any one of the test
parameters, then the display of the test parameter
to which the third parameter key currently
corresponds will be canceled.
5. Now the Initial screen is displaying the values
of the parameters Cs and D.
For details, refer to Section 4.2, "Setting the Parameters to be Displayed".