24
_____________________________________________________________________________________________
3.3 Basic Measurement
______________________________________________________________________________________________
O
en Circuit Com
ensation Screen
Confirmation Screen
NOTE
Data Determination Screen
4. Press the key so as to select ALL
compensation, with which open circuit
compensation values for all the test frequencies
will be determined and adjusted.
5. A Confirmation screen will be displayed for
confirmation of ALL open circuit compensation.
If it is OK to proceed, press the key.
Check again - are the test leads definitely out of
mutual contact ?
6. When you press the key, the ALL open
circuit compensation process starts.
After about 2 minutes, the determination and
adjustment of the open circuit compensation
values is complete.
If an error message appears, refer to Section
4.7.5.
To Next Page
Loading...
