Hioki DT4261 - Page 115

109
Input and Measurement Specications
Response time Time from when the power is turned on until the
value is displayed (open terminal)
• AC voltage, resistance: 2 seconds or less
Time until the displayed value falls within the
accuracy specication range
• AUTO V: 1.2 seconds or less
(Open terminal → 100 V, 50 Hz, auto range)
• DC voltage: 0.8 seconds or less
(Open terminal → 100 V DC, auto range)
• AC voltage: 0.7 seconds or less
(Open terminal → 100 V, 50 Hz, auto range)
• Resistance: 1.1 seconds or less
(Open terminal → Terminal short circuit, auto
range)
Display update rate* • Measured value: 5 times/second (excluding
electrostatic capacity and
frequency after the range is
xed)
0.05 to 5 times/second (When
measuring electrostatic
capacitance, varies with the
electrostatic capacitance value.)
1 to 2 times/second (frequency)
• Bar graph: 25 times/second
* The range movement time is not included.
Peak value detection
time width
1 ms or more
HIOKI DT4261A961-00