87
Auto Power Save (APS)
4.7 Auto Power Save (APS)
The auto power save function saves on battery consumption. When
the power is turned on, the auto power save function is automatically
enabled. If the instrument is to be used continuously for an extended
period of time, disable the auto power save function.
Enabled (
[APS]
lights up)
(Default setting)
No
operation
for approx.
15 minutes
Sleep mode
([APS] blinks 30 seconds
before.)
(Continued for
approx. 45 minutes.)
Power OFF
Turn the rotary switch to OFF after use. A small amount of battery power is
used in sleep mode.
Resuming from sleep mode
Press any key or turn the rotary switch.
Resuming from a power shutdown
Set the rotary switch to OFF and turn on the power again.
Selecting or with the rotary switch while the test leads
are connected to the current measurement terminal (A terminal)
will cause the instrument to turn back on.
Disabling the APS function
With the power o, turn the rotary switch while holding down the
HOLD key.
[APS] goes o
(Any position)
Enabling the APS function again
Turn the power o and then back on again.
[APS] lights up
To Next Page
Loading...
