30
Inserting/Replacing Batteries
2.2 Inserting/Replacing Batteries
Before using the instrument rst time, insert three LR6 alkaline
batteries.
See: “Battery installation/replacement procedure” (p. 33)
Before measurements, check that the battery level is sucient.
When the battery charge is low, replace the batteries.
See: “Battery warning indicator” (p. 28)
WARNING
Before removing the battery cover,
disconnect the instrument from the object
under measurement and set the rotary
switch to OFF.
Failure to do so could cause electric shock. When
the instrument is connected to the object under
measurement, the battery contacts are regarded as
high-voltage parts.
Do not short-circuit the battery.
Do not charge the battery.
Do not disassemble the battery.
Do not throw the battery into a re.
Doing so can cause the battery to explode, resulting in
bodily injury.
To Next Page
Loading...
