76
Hold Function (HOLD)
Retaining the measured value automatically (AUTO
HOLD)
Display update is automatically stopped once the measured value
stabilizes. (The bar graph is updated.) (Default setting: OFF)
1 s
Press for at least 1 second.
(Press it for at least 1 second again to
cancel the hold function.)
Before auto holding (Standby for the
measured value to stabilize)
blinks
blinks
After auto holding
When the measured value stabilizes, a buzzer
sounds and the measured value is retained.
lights up
lights up
Disconnect the test leads from the object
under measurement.
Connect the test leads to the next object
to be measured.
When the measured value stabilizes, a buzzer
sounds and the new measured value is retained.
lit
Press
Returns to the standby state for the measured
value to stabilize.
blinks
• If the input signal is too small for the relevant range, the measured
value cannot be automatically retained.
• The measured value will be automatically retained once it
stabilizes within the stable range (which takes approx. 2 seconds).
To Next Page
Loading...
