18
Precautions for Use
For continuity check, diode test, and measurement of
resistance or electrostatic capacity
NOTICE
Before performing measurement, verify that the
current and voltage of the measurement signal
do not exceed the rating of the object to be
measured.
See: Measurement current and open circuit voltage in
the accuracy table (p. 117)
Applying a signal that exceeds the rating could damage
the object to be measured.
If the instrument is not to be used for an extended
period of time
NOTICE
Remove the battery if the instrument will not be
used for an extended period of time.
Failure to do so may cause the battery to leak,
damaging the instrument.
To Next Page
Loading...
