Hioki LR8402-20 - Page 230

10.7 Sending E-Mail
218
Increment/decrement by 1
Increment/decrement by 10
1
Numerical Settings
Character Settings
See: 
"3.7 Entering Titles and Comments
(as needed)" (p. 71)
1 Enable or disable the [Send Mail to
Address].
Up to three addresses can be entered.
(When [Send Mail to Address]) is
enabled)
2 Enter the [Send Mail to Address].
Enter the recipient's e-mail address for
notifications.
3 Set each item (p. 219).
4 Configuring [Timing].
Select the check boxes for the desired
mail sending criteria.
Setting options: (
 : default setting)
Off
 Mail is not sent.
On Mail is sent.
Setting options:
Up to 32 characters
(e.g., abc@xyz.xx.xx)
Setting options:
Start
Trig
Send mail when a Start trigger
event occurs.
(for example, to notify a start-
ing trigger)
Stop
Trig
Send mail when a Stop trigger
event occurs.
Alarm Send mail when an alarm
event occurs.
Start
Bup
Send mail upon recovery from
a power outage.
Mem
Full
Send mail when HiLogger in-
ternal memory is full and old
data be
gins to be overwritten.
Mail is sent only once: the first
t
ime memory becomes full.
Card
Full
Send mail when the CF card or
USB flash drive becomes full.
2
3
4