Hioki LR8402-20 - Page 231

10.7 Sending E-Mail
219
3
Chapter 10 Connection to a PC (Communication)
10
Setting Items
Mail Server Enter the mail server name. Specifies the SMTP mail server.
IP Address Set the IP address of the mail server. Specifies the SMTP mail server.
IP / Port Set the port address of the mail server. Default is port 25.
Sender
Address
Enter the sender's e-mail address.
Sender Name Enter the sender's name.
Subject Enter the subject for mail notifications.
Message Enter the text for mail notifications.
Attach data Enable/disable attachment of measurement data (Data sends only when
Start trigger, Stop trigger, or alarm event occurs).
Setting options
Up to 32 characters.
Setting options
_._._._ (where _ is 0 to 255, e.g., 192.168.1.100)
Setting options
1 to 65535
Setting options
Up to 32 characters.
(e.g., logger@xyz.xx.xx)
Setting options
Up to 32 characters. (e.g.,
logger)
Setting options
Up to 32 characters. (e.g.,
logger_mail)
Setting options
Up to 32 characters.
(e.g., E-mail from logger)
Setting options: (  : default setting)
Off
 Do not attach measurement data to e-mail.
On Attach measurement data to e-mail.