Basic Settings
[ Basic Settings > System ]
19
RM GUI GRS
Release
8.0
09/2019
Temperature [°C]
Displays the current temperature in the device in °C.
You activate the monitoring of the temperature thresholds in the
Diagnostics > Status Configuration >
Device Status dialog.
Upper temp. limit [°C]
Specifies the upper temperature threshold in °C.
The “Installation” user manual contains detailed information about setting the temperature
thresholds.
Possible values:
-99..99
(integer)
If the temperature in the device exceeds this value, then the device generates an alarm.
Lower temp. limit [°C]
Specifies the lower temperature threshold in °C.
The “Installation” user manual contains detailed information about setting the temperature
thresholds.
Possible values:
-99..99
(integer)
If the temperature in the device falls below this value, then the device generates an alarm.
LED status
This frame displays the states of the device status LEDs at the time of the last update. The
“Installation” user manual contains detailed information about the device status LEDs.
Parameters Color Meaning
Status
There is currently no device status alarm. The device status is OK.
There is currently at least one device status alarm. Therefore, see the
Device status
frame above.
Power
Device variant with 2 power supply units:
Only one supply voltage is active.
Device variant with 1 power supply unit:
The supply voltage is active.
Device variant with 2 power supply units:
Both supply voltages are active.
RM
The device is neither operating as a
MRP
ring manager nor as a
DLR
supervisor.
Loss of redundancy reserve.
The device is operating as a
MRP
ring manager.
Redundancy reserve is available.
The device is operating as a
MRP
ring manager.
To Next Page
Loading...
