Hirschmann GREYHOUND GRS1020 - Port Status Indication

Operation diagnosis
13.5
Port status indication
201
UM Config GRS
Release
8.0 09/2019
13.5 Port status indication
Perform the following steps:
The dialog displays the device with the current configuration. Furthermore, the dialog indicates the
status of the individual ports with a symbol.
The following symbols represent the status of the individual ports. In some situations, these
symbols interfere with one another. When you position the mouse pointer over the port icon, a
bubble help displays a detailed description of the port state.
 Open the Basic Settings > System dialog.
Table 35: Symbols identifying the status of the ports
Criterion Symbol
Bandwidth of the port
10 Mbit/s
Port activated, connection okay, full-duplex mode
100 Mbit/s
Port activated, connection okay, full-duplex mode
1000 Mbit/s
Port activated, connection okay, full-duplex mode
Operating state
Half-duplex mode enabled
See the
Basic Settings > Port dialog, Configuration tab, Automatic configuration
checkbox, Manual configuration field and Manual cable crossing (Auto. conf. off)
field.
Autonegotiation enabled
See the
Basic Settings > Port dialog, Configuration tab, Automatic configuration
checkbox.
The port is blocked by a redundancy function.
AdminLink
The port is deactivated, connection okay
The port is deactivated, no connection set up
See the
Basic Settings > Port dialog, Configuration tab, Port on checkbox and
Link/Current settings field.