Operation diagnosis
13.11
Reports
212
UM Config GRS
Release
8.0
09/2019
13.11.2 Syslog
The device enables you to send messages about device internal events to one or more Syslog
servers (up to 8). Additionally, you also include SNMP requests to the device as events in the
Syslog.
Note: To display the logged events, open the
Diagnostics > Report > Audit Trail
dialog or the
Diagnostics > Report > System Log
dialog.
Perform the following steps:
In the
SNMP logging
frame, configure the following settings for read and write SNMP requests:
Perform the following steps:
Open the
Diagnostics > Syslog
dialog.
To add a table entry, click the button.
In the
IP address
column, enter the IP address of the Syslog server.
In the
Destination UDP port
column, specify the UDP port on which the Syslog server expects
the log entries.
In the
Min. severity
column, specify the minimum severity level that an event requires for the
device to send a log entry to this Syslog server.
Mark the checkbox in the
Active
column.
To enable the function, select the
On
radio button in the
Operation
frame.
To save the changes temporarily, click the button.
Open the
Diagnostics > Report > Global
dialog.
Enable the
Log SNMP get request
function for the device in order to send SNMP Read
requests as events to the Syslog server.
To enable the function, select the
On
radio button in the
SNMP logging
frame.
Enable the
Log SNMP set request
function for the device in order to send SNMP Write
requests as events to the Syslog server.
To enable the function, select the
On
radio button in the
SNMP logging
frame.
Choose the desired severity level for the get and set requests.
To save the changes temporarily, click the button.
enable
Change to the Privileged EXEC mode.
configure
Change to the Configuration mode.
logging host add 1 addr 10.0.1.159
severity 3
Adds a new recipient in the Syslog servers list. The
value
3
specifies the severity level of the event that
the device logs. The value
3
means
Error
.
logging syslog operation
Enable the
Syslog
function.
exit
Change to the Privileged EXEC mode.
show logging host
Display the Syslog host settings.
To Next Page
Loading...
