Hirschmann GREYHOUND GRS1020 - Configuring GVRP

Advanced functions of the device
14.3
GARP
228
UM Config GRS
Release
8.0 09/2019
14.3.2 Configuring GVRP
You use the GVRP function to allow the device to exchange VLAN configuration information with
other GVRP devices. Thus reducing unnecessary Broadcast and unknown Unicast traffic. Besides
the GVRP function dynamically creates and manages VLANs on devices connected through
802.1Q trunk ports.
The following example describes the configuration of the GVRP function. The device lets you
exchange VLAN configuration information with other GVRP devices.
Perform the following steps:
 Open the Switching > GARP > GVRP dialog.
 To exchange VLAN configuration information with other GVRP devices, mark checkbox in
the GVRP active column for the port.
 To save the changes temporarily, click the button.
enable
Change to the Privileged EXEC mode.
configure
Change to the Configuration mode.
interface 3/1
Change to the interface configuration mode of
interface 3/1 .
garp gvrp operation
Enabling the GVRP function on the port.
exit
Change to the Configuration mode.
garp gvrp operation
Enabling the GVRP function globally.