Hirschmann GREYHOUND GRS1020 - Adjust the Settings

Access to the device
3.1
Authentication lists
57
UM Config GRS
Release
8.0 09/2019
3.1.4 Adjust the settings
Example:
Set up a separate authentication list for the application WebInterface which is by default included
in the authentication list defaultLoginAuthList . The device forwards authentication requests to
a RADIUS server in the network. As a fall-back solution, the device authenticates users using the
local user management.
Perform the following steps:
 Create an authentication list loginGUI .
 Select the policies for the authentication list loginGUI .
 Assign an application to the authentication list loginGUI .
 Open the Device Security > Authentication List dialog.
 Click the button.
The dialog displays the Create window.
 Enter a meaningful name in the Name field.
In this example, enter the name loginGUI .
 Click the Ok button.
The device adds a new table entry.
enable
Change to the Privileged EXEC mode.
configure
Change to the Configuration mode.
authlists add loginGUI
Creates the authentication list loginGUI .
 In the Policy 1 column, select the value radius .
 In the Policy 2 column, select the value local .
 In the Policy 3 to Policy 5 columns, select the value reject to help prevent further fall-back.
 In the Active column, mark the checkbox.
 To save the changes temporarily, click the button.
authlists set-policy loginGUI radius
local reject reject reject
Assigns the policies radius , local and reject to the
authentication list loginGUI .
show authlists
Displays the authentication lists that are set up.
authlists enable loginGUI
Activates the authentication list loginGUI .
 In the Device Security > Authentication List dialog, highlight the authentication list loginGUI .
 Click the button and then the Allocate applications item.
The dialog displays the Allocate applications window.
 In the left column, highlight the application WebInterface .