Hirschmann GREYHOUND GRS1020 - Disabling the Hidiscovery Access

Assistance in the protection from unauthorized access
7.5
Disabling the HiDiscovery access
92
UM Config GRS
Release
8.0 09/2019
7.5 Disabling the HiDiscovery access
HiDiscovery lets you assign IP parameters to the device over the network during commissioning.
HiDiscovery communicates in the device management VLAN without encryption and
authentication.
After the device is commissioned, we recommend to setHiDiscoveryto read-only or to disable
HiDiscovery access completely.
Perform the following steps:
 Open the Basic Settings > Network dialog.
 To take away write permission from the HiDiscovery software, in the HiDiscovery protocol v1/
v2 frame, specify the value readOnly in the Access field.
 To disable HiDiscovery access completely, select the Off radio button in the HiDiscovery
protocol v1/v2 frame.
 To save the changes temporarily, click the button.
enable
Change to the Privileged EXEC mode.
network hidiscovery mode read-only
Disable write permission of the HiDiscovery
software.
no network hidiscovery operation
Disable HiDiscovery access.