Diagnostics
[ Diagnostics > Status Configuration > Security Status ]
238
RM GUI GRS
Release
8.0
09/2019
6.1.2 Security Status
[ Diagnostics > Status Configuration > Security Status ]
This dialog gives you an overview of the status of the safety-relevant settings in the device.
The device displays its current status as
error
or
ok
in the
Security status
frame. The device
determines this status from the individual monitoring results.
The device displays detected faults in the
Status
tab and also in the
Basic Settings > System
dialog,
Security status
frame.
The dialog contains the following tabs:
[Global]
[Port]
[Status]
[Global]
Security status
Security status
Displays the current status of the security-relevant settings in the device. The device determines
the status from the individual monitored parameters.
Possible values:
error
The device displays this value to indicate a detected error in one of the monitored parameters.
ok
Traps
Send trap
Activates/deactivates the sending of SNMP traps when the device detects changes in the
monitored functions.
Possible values:
marked
The sending of SNMP traps is active.
If the device detects a change in the monitored functions, then the device sends an SNMP trap.
unmarked
(default setting)
The sending of SNMP traps is inactive.
The prerequisite for sending SNMP traps is that you enable the function in the
Diagnostics > Status
Configuration > Alarms (Traps)
dialog and specify at least 1 trap destination.
To Next Page
Loading...
