Switching
[ Switching > L2-Redundancy > Link Aggregation ]
221
RM GUI GRS
Release
8.0
09/2019
DFT
EXP
For further information on the values, see the description of the
LACP actor oper state
column and
the standard IEEE 802.1AX-2014.
Buttons
You find the description of the standard buttons in section “Buttons” on page 13.
Opens the
Create
window to add a new LAG interface entry to the table or to assign a physical port
to a LAG interface.
In the
Trunk port
drop-down list, you select the LAG interface number.
In the
Port
drop-down list, you select the number of a physical port to assign to the LAG interface.
After you create a LAG interface, the device adds the LAG interface to the table in the
Basic
Settings > Port
dialog,
Statistics
tab.
To Next Page
Loading...
