Basic Settings
[ Basic Settings > Network ]
26
RM GUI GRS
Release
8.0
09/2019
Signal
Activates/deactivates the flashing of the port LEDs as does the function of the same name in the
HiDiscovery software. The function lets you identify the device in the field.
Possible values:
marked
The flashing of the port LEDs is active.
The port LEDs flash until you disable the function again.
unmarked
(default setting)
The flashing of the port LEDs is inactive.
IP parameter
This frame lets you assign the IP parameters manually. If you have selected the
Local
radio button
in the
Management interface
frame,
IP address assignment
option list, then these fields can be edited.
IP address
Specifies the IP address under which the device management can be accessed through the
network.
Possible values:
Valid IPv4 address
Netmask
Specifies the netmask.
Possible values:
Valid IPv4 netmask
Gateway address
Specifies the IP address of a router through which the device accesses other devices outside its
own network.
Possible values:
Valid IPv4 address
Buttons
You find the description of the standard buttons in section “Buttons” on page 13.
To Next Page
Loading...
